Hardbar's new camcorder mount that fits not only the
large diameter (2 inch) diameter Hardbar harness barsand will fit all Sharkbars
as well as other brands down to 1.5 inches in diameter. It can be used above the
bar, below the bar, in front or towards the rear. It is CNC machined from DuPont
Delrin so it will not mar or scratch the powdercoating on the bar and is
lightweight. It also has a quick release feature where you insert the stainless
steel stud with the supplied allen wrench, spin on the knob (with a brass thread
insert), slide it into the slot and move slightly to the side to engage the
desired notched location and tighten the knob. It allows you to position the
camera along the bar, point it up, down, left, right. This is the first one, and
production versions will be a little more rounded off in the corners, but the
kit includes everything shown here including all stainless steel fasteners and
even the allen wrenches. |