2020-2024 Chevrolet Corvette C8 Front Lift Lowering Collar Kit For Cars With Front Lift Option E60 With Gps Front Lift
VMS Racing front lowering kit for the C8 Corvette WITH the Front Lift Option E60 (with GPS front lift). The VMS Racing lowering kit is a simple replacement of the stock front lift actuator seat, and is designed to lower the front of your C8 Corvette either 0.75 or 0.50 inches. If you do not use the 0.25 spacer, then you get a 0.75 inch drop, and if you use the spacer you get a 0.50 inch drop. The spacer is a great tool to fine tune your ride height, especially if you plan to lower your car even further than 0.75 inches with the addition of lowering springs. This kit will allow you to drop your car .075 inches, just like the factory Z51 cars that do not have the front lift option. In the rear you can lower the car with the factory adjustable collars, you will need a coilover wrench set. Click on the red link below for the C8 coilover wrench set. This kit also comes with a de-pin tool so that you can easily de-pin the shock connector on the mag ride cars.
Features:
- Machined from 6061 T-6 billet aluminum
- Lowers you front end 0.75 or 0.50 inches
- Comes with the Mag Ride de-pin tool for the shock connector
- Designed in the USA
- Red anodized with the VMS laser logo
- Retains full functionality of your front lift option, your car will still rise up.
- No trimming is needed of your bump stops as GM designed the Z51 cars to be able to be lowered .75 inches (maximum factory allowed). The bump stops on all C8's are the same, so no trimming is required
|