This eight piece set of " show quality" triple chrome plated 16 ga. steel covers fits over the top of your plenum to add some extra sparkle to that area. They are laser cut to perfectly match the outline of the runners on your plenum. They are held in place with double sided tape. For a dynamite look, you can paint your plenum cover to match your body or paint it black prior to installing the Chrome Runner Covers. Installation time is about 30 minutes. Fits 2014-2015
INSTALLATION INSTRUCTIONS 1. Remove the fuel rail covers with the word CORVETTE from each side of your engine. 2. Clean the top of your plenum with denatured alcohol to remove any grease or road grime that might prevent adhesion of the two sided tape. 3. Trial fit the Chrome Runner Covers by positioning one or more of the Chrome Runner Covers on your plenum aligning the edges of the Chrome Covers with the edges of the raised runner outline on your plenum and the large end of the Chrome Covers with the round opening in your plenum near the fuel injectors. ( DO NOT REMOVE THE PROTECTIVE FILM FROM THE TWO SIDED TAPE DURING THIS TRIAL FIT ). 4. When you are satisfied with the way they should fit, remove the protective film from the two sided tape on the back of The Chrome Cover and position it on your plenum as you did in the trial fit. Install all eight of the Chrome Covers one at a time. 5. Apply even pressure with your hand to each Chrome Cover in the area of the tape to insure good adhesion. 6. Reinstall your fuel rail covers |