The Original Window Valet™
* Remote Control Power Windows(see video at bottom of
page) * Window Venting Support *
High Speed/RPM Report * Subtle Alarm
Mode * Works with stock remote key FOB
Once installed, the Window Valet™ for C6/XLR is configured by using the
buttons on the Driver's Instrument Center. A few clicks tells the Window Valet™
which features to enable.
Description: The Window Valet™ for C6/XLR provides remote power window
control for the 2005 and newer Corvette and for the 2004 and newer Cadillac XLR.
Additional bonus features can be optionally configured and are designed for the
C6, but the subtle alarm mode also works well with the XLR.
Installation: The Window Valet™ for C6/XLR plugs into the diagnostics
port underneath the steering column, just passed the edge of the dash trim.
There's no configuration required. Just plug it in! The Window Valet™ for C6/XLR
does not reprogram any of the car's computers. So to reverse the install, just
unplug the unit, and the car will immediately revert back to stock.
Usage: To lower the windows via remote, press the remote unlock button three
times. To raise the windows, press the remote lock button three times. (Or to
prevent the car from blowing its horn multiple times, unlock-unlock-lock may be
used.) For the features to activate, the buttons must be pressed in rapid
succession, with less than one second between two sequential clicks.
Special Window Venting Feature: The window venting feature allows you to use
the remote to leave the windows down about half-an-inch for airflow on hot days.
To use this feature, simply issue the remote window up command when both windows
are already in the fully up position. The Window Valet™ for C6/XLR will
recognize that the windows are already up and assume that you want to vent the
windows. This feature, just like the remote window control, does not require any
additional configuration.
Bonus Features: The Window Valet™ for C6/XLR includes several bonus features
in addition to remote window control. There is a special "subtle alarm" warning
mode, an unlock on park brake feature, and a high speed/tach report (only for
C6).
1 - The "subtle alarm" mode will cause the horn to toot three times whenever
someone pulls on an outside door handle while the car is locked. If a valid FOB
is detected and the door unlocks because the C6/XLR's passive mode is enabled,
the horn will not sound. It's a "you're busted" message to kids trolling for
unlocked cars.
2 - "Unlock on brake" will unlock the doors whenever the park brake is set.
It will re-lock the doors whenever the brake is released. This feature is only
available when the engine is running. It's convenient when dropping off a
passenger when driving the C6 manual transmission. It's not really intended for
the XLR with an automatic transmission and a foot pedal park brake, but it does
work.
3 - The "high speed/tach report" will show the highest speed and the highest
RPM recorded by the Window Valet™ for C6 since it was last cleared. These values
are shown directly on the speedometer and tachometer's analog needles. Only mph
on a 200mph style gauge is available. To recall the values, press and hold RESET
on the Instrument Panel Cluster while tapping unlock six (6) times on the
driver's door panel. Speeds up to 100mph will be shown. To show the remainder
over 100mph, press the GAUGES button. Press RESET again to exit, or press FUEL
to clear the high values and exit. This feature is not available on the
XLR. Bonus Feature Configuration Process: To configure bonus features 1 and
2, press the driver's door panel unlock button quickly six (6) times. The
tachometer will move to 1 krpm and the speedometer will either read 30 mph or 0
mph depending on whether or not the first feature (Subtle Alarm) is configured
to be ON or OFF. Pressing the FUEL button will then toggle the ON/OFF
configuration of the Subtle Alarm mode. Pressing another button, such as GAUGES
will recall the configuration status for another feature. That feature can then
be toggled ON or OFF by simply pressing its associated button again until the
desired setting is achieved. Press RESET to exit configuration mode. All changes
are automatically saved inside the Window Valet™ for C6. This data will be saved
if the unit is removed and re-installed later.
When configured at the factory, all bonus features are disabled so that no
one is surprised by an unexpected action, such as the doors unlocking when the
handbrake is set. Here's an example that shows exactly how to set the unlock on
brake feature:
Example: To set the Unlock on brake feature, enter configuration mode by
pressing unlock on the driver door panel six (6) times. Note that the tachometer
is now reading 1 KRPM indicating that configuration mode is active and that the
Subtle Alarm feature is being reviewed. Press the GAUGES button on the
Instrument Panel Cluster to review the Unlock on brake feature. If fresh from
the factory, the speedometer should now read 0 mph (feature off) while the
tachometer will read about 2 KRPM. Press the GAUGES button again to activate the
feature and note that the speedometer will now show 30 mph. (Pressing the GAUGES
button another time will toggle the feature off again and indicate so by moving
the speedometer back to 0 mph.) Press RESET on the Instrument Panel Cluster to
exit configuration mode, or select another features to review or change.
Note: The C6/XLR may toot its horn on the second and third remote lock
commands even if its horn configuration is set to silent when locking. This is a
feature of the C6/XLR, not the Window Valet™, and is designed to act as a lock
confirmation. To prevent the horn from blowing when remotely raising the
windows, you may use the alternate window up command sequence: Unlock, Unlock,
Lock.
|