Pfadt Racing is proud to offer the wheel bearings that are up to
the challenge for your racing Corvette.
Our SKF wheel bearings are only for 1997-2008
Corvettes!
2009 and up use ZR1 Wheels bearings available from
us.
Replacing your wheel bearings two to three times a season is no
longer necessary. These true race quality bearings from SKF solve
many of the known issues with other wheel bearings on the market.
These SKF Corvette Racing hubs offer the same technology as the ZR1
hub for the C5 and C6 Corvette.
Designed for durability and to maintain preload at sustained
loading of 1.2g, these units were tested and proven on some of the
European GT3 Corvettes for an entire race season. Don't settle for
a tapered roller design. Tapered rollers are relatively effective
for handling load, but have high friction and generate heat and
rolling resistance which can lead to premature failure.
SKF Asymmetric - Roll formed design benefits:
1. High camber stiffness compared to a symmetric ball design
2. Reduced brake judder and piston knock-back
3. Roll formed and self retained without need for a stub
shaft
4. Increased stiffness for better brake performance under high
loads, higher preloads, less than 10 micron run-out on flange
face
The SKF hubs offered by Pfadt Racing have the appropriate speed
sensors for 1997-2008 Corvettes. Our hubs eliminate the need for
frequent replacement, reduce long pedal/brake pad knock back, poor
pad wear, and reduce the potential for broken flanges. If you're
going to race, Pfadt/SKF hubs are the only game in town!
Introductory price is $380 each.
Our hubs ship with high-strength stock length studs. ARP 2 1/2
inch studs are available for $25 for the set of 5, or we can
install them for you for $35.
Don't take your chances with an inexpensive "AutoParts Store"
brand bearing and end up spending your race weekends changing wheel
bearings in the paddock. Buy race quality parts from the race
quality line-up at Pfadt.
|